Minute Man SSL-WATER

Instrukcja obsługi Minute Man SSL-WATER

(1)
  • SSL-WATER User’s Manual
    IMPORTANT: Read all of the instructions before
    attempting to install the SSL-WATER leak sensor.
    DESCRIPTION
    The SSL-WATER sensor is a device, which connects with
    SSL-EMD. When water permeates into the sensor cable, the
    conductivity enhances the intensity of electric current and the
    alarm will be triggered. Through the SNMP-SSL card, the use
    r
    can monitor it and receive notifications of the alarms. The
    following cable type comes with the water leak sensor:
    Type A: 1m water leak sensor connected to 1.2m cable
    APPLICATION
    Common usage are areas where mission-critical equipment is
    being maintained, including data rooms, data centers, clean
    rooms, utility corridors, laboratories, telecommunication
    facilities, storage areas, elevator shafts, drip pans unde
    r
    wate
    r
    -cooled equipment, and many more. The most common
    application for water leak detection is under raised floors. It is
    common for water leak sensors to be installed under the
    raised floor as well as in the ceiling above equipment.
    Facilities and equipment that use water-cooled technology
    have started to add water leak sensors to provide early
    warning of water leaks. The water leak sensor is installed
    around the supply and return water lines.
    INSTALLATION
    1. Loosen the screws on SSL-EMD.
    2. Connect the wires of SSL-WATER sensor to the SSL-EMD
    A
    larm-1 and/or Alarm-2, and then tighten the screws.
    3. Connect the straight-through CAT5 network cable from the
    SNMP-SSL card’s RJ45 connector labeled “COM” to the
    connector labeled “010101” on the SSL-EMD.
    4. Verify that the SNMP-SSL card has a network connection and
    is powered on.
    5. Check the LED (Power/Status) of SSL-EMD, it will flash ever
    y
    5-seconds.
    6. Open a Web browser and connect to the SNMP-SSL card.
    7. Change the setting of “SSL-EMD Status” from “Disable” to
    “Auto” on the EMD Configuration page.
    8. Set the status of Alarm-1 and/or Alarm-2 to “Normal Open”.
    9. Place the SSL-WATER sensor in the desired location.
    10. The installation of the SSL-WATER sensor is complete. See
    the SNMP
    -
    SSL User
    s Manual.
    LIMITED PRODUCT WARRANTY
    Para Systems Inc. (Para Systems) warrants this equipment, when
    properly applied and operated within specified conditions, against
    faulty materials or workmanship for a period of three years from the
    date of original purchase by the end user. For equipment sites within
    the United States and Canada, this warranty covers repair o
    r
    replacement of defective equipment at the discretion of Para
    Systems. Repair will be from the nearest authorized service center.
    Replacement parts and warranty labor will be borne by Para Systems.
    For equipment located outside of the United States and Canada, Para
    Systems only covers faulty parts. Para Systems products repaired
    or replaced pursuant to this warranty shall be warranted for the
    remaining portion of the warranty that applies to the original product.
    This warranty applies only to the original purchaser who must have
    properly registered the product within 10 days of purchase.
    The warranty shall be void if (a) the equipment is damaged by the
    customer, is improperly used, is subjected to an adverse operating
    environment, or is operated outside the limits of its electrical
    specifications; (b) the equipment is repaired or modified by anyone
    other than Para Systems or Para Systems-approved personnel; or (c)
    has been used in a manner contrary to the product's operating
    manual or other written instructions.
    A
    ny technical advice furnished before or after delivery in regard to use
    or application of Para Systems’s equipment is furnished without
    charge and on the basis that it represents Para Systems’s best
    j
    udgment under the circumstances, but it is used at the recipient's
    sole risk.
    EXCEPT AS PROVIDED HEREIN, PARA SYSTEMS MAKES NO
    WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
    WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
    PARTICULAR PURPOSE. Some states do not permit limitation o
    f
    implied warranties; therefore, the aforesaid limitation(s) may not appl
    y
    to the purchaser.
    EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL PAR
    A
    SYSTEMS BE LIABLE FOR DIRECT, INDIRECT, SPECIAL,
    INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF
    THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE
    POSSIBILITY OF SUCH DAMAGE. Specifically, Para Systems is
    not liable for any costs, such as lost profits or revenue, loss o
    f
    equipment, loss of use of equipment, loss of software, loss of data,
    cost of substitutes, claims by third parties, or otherwise. The sole
    and exclusive remedy for breach of any warranty, expressed o
    r
    implied, concerning Para Systems’s products and the only obligation
    of Para Systems hereunder, shall be the repair or replacement o
    f
    defective equipment, components, or parts; or, at Para Systems’s
    option, refund of the purchase price or substitution with an equivalent
    replacement product. This warranty gives you specific legal rights
    and you may also have other rights, which vary from state to state.
    OBTAINING TECHNICAL ASSISTANCE
    Para Systems (Minuteman UPS) Technical Support:
    Phone: 1-972-446-7363
    Fax: 1-972-446-9011
    Web: www.minutemanups.com/support/con_tech2.php
    www.minutemanups.com © Copyright 2008 34000364 R1
Minute Man SSL-WATER

Potrzebujesz pomocy?

Liczba pytań: 0

Czy masz pytanie dotyczące Minute Man SSL-WATER lub potrzebujesz pomocy? Zadaj pytanie tutaj. Podaj jasny i wyczerpujący opis problemu oraz pytanie. Im więcej szczegółów swojego problemu i pytania podasz, tym łatwiej będzie innym właścicielom Minute Man SSL-WATER poprawnie odpowiedzieć na Twoje pytanie.

Tu możesz bezpłatnie wyświetlić instrukcję dotyczącą Minute Man SSL-WATER. Ta instrukcja należy do kategorii Nieskategoryzowane i otrzymała oceny od 1 osób ze średnią 6.2. Ta instrukcja jest dostępna w następujących językach: Angielski. Czy masz pytanie dotyczące Minute Man SSL-WATER lub potrzebujesz pomocy? Zadaj pytanie tutaj

Specyfikacje Minute Man SSL-WATER

Ogólne
Marka Minute Man
Model SSL-WATER
Produkt Nieskategoryzowany
EAN 784755154378, 7847551543784
Język Angielski
Typ pliku PDF
Szczegóły Techniczne
Technologia łączności Przewodowa
Przeznaczenie -
Model Wol✗stojący
Długość kabla 1.2m
Zakres pomiaru wilgotności -%
Warunki pracy
Zakres temperatur (przechowywanie) -°C

InstrukcjaObslugiPDF.pl

Szukasz instrukcji? InstrukcjaObslugiPDF.pl zapewnia, że szybko znajdziesz instrukcję, której szukasz. Nasza baza danych zawiera ponad milion instrukcji PDF od ponad 10 000 marek. Codziennie dodajemy najnowsze instrukcje, abyś zawsze znalazł produkt, którego szukasz. To bardzo proste: po prostu wpisz nazwę marki i rodzaj produktu w pasku wyszukiwania, a od razu będziesz mógł przejrzeć instrukcję online za darmo.

InstrukcjaObslugiPDF.pl

© Copyright 2020 InstrukcjaObslugiPDF.pl. Wszystkie prawa zastrzeżone.

Ta strona korzysta z ciasteczek aby świadczyć usługi na najwyższym poziomie. Dalsze korzystanie ze strony oznacza, że zgadzasz się na ich użycie.

Dowiedz się więcej