Instrukcja obsługi Malvern 1020

  • USER INSTRUCTIONS
    tentwenty & twentytwentysix
    CONDENSING BOILERS
    INFORMATION CONCERNING YOUR BOILER
    You are the owner of a Malvern High Efficiency Condensing Boiler and due to the
    way it works it will appear to produce a lot of steam from the terminal; this is harmless
    vapour and quite normal. The boiler requires a drain to be permanently connected,
    your installer has done this, it must not be disconnected or removed. The Installer
    should also have left you your Logbook. The Gas Safety (Installations
    and Use) Regulations makes it illegal for gas appliances to be installed or serviced
    by persons not CORGI Registered Operatives. All Registered Installers carry a
    CORGI ID card and have a registration number and this should be recorded in your
    Logbook. You can check your installer is CORGI registered by calling CORGI direct
    on:- 01256 372300
    IMPORTANT: DO NOT DISTURB APPLIANCE CASE.
    ELECTRICAL SUPPLY TO YOUR BOILER
    The boiler must be connected to a 230v ~ 50 Hz supply with a 3 Amp fuse rating.
    THE APPLIANCE MUST BE EARTHED.
    TO IGNITE YOUR BOILER
    With the Electricity supply switched on, the
    power
    lamp will be on. When the
    system programmer and thermostats are in a demand position and the front panel
    boiler thermostat fully clockwise, the boiler
    running
    lamp will be lit and the boiler
    will start automatically. The
    running
    lamp will go out when the system thermostats
    are satisfied or if the programmer is off.
    If the boiler fails to start and the
    lockout
    lamp is lit reset by turning the boiler
    thermostat to off then back on again.
    If the boiler does not start after using the reset allow the boiler to cool, then reset
    again. If this still does not succeed in getting the boiler to run, or if a fault is suspected
    turn the boiler and supply off and call the assistance of a Corgi registered Engineer.

Zadaj pytanie

Zadaj tutaj pytanie dotyczące Malvern 1020 innym właścicielom produktu. Podaj jasny i wyczerpujący opis problemu i swoje pytanie. Im lepiej opisany jest twój problem i pytanie, tym łatwiej innym właścicielom Malvern 1020 udzielić ci dobrej odpowiedzi.

Zobacz tutaj bezpłatnie instrukcję Malvern 1020. Przeczytałeś instrukcję, ale czy odpowiada ona na twoje pytanie? Zadaj pytanie innym użytkownikom Malvern 1020 na tej stronie.